Selecting a valve for pressure regulation in a hydraulic system

Posted in CategoryIntroduction to Darasa Forum
  • Z
    Zhires87 4 weeks ago

    We need to select a valve to regulate the pressure on the hydraulic test bench. An older model is currently installed, but the pressure sometimes rises above the set value by about 10–15 bar. The system operates in different modes, so the pressure has to be adjusted several times per shift. I’ve looked at a few valves, but I’m not sure which one would be best suited for this application. What specifications would you check before making a selection?


  • C
    Chonge 4 weeks ago

    On our equipment, the valve is adjusted quite frequently, especially when the type of test changes. Previously, operators would record the settings only in a paper log, which sometimes led to confusion. Now, there is a separate entry for each mode with the necessary parameters. This has greatly simplified the work, especially when several people use the equipment during a shift.

  • D
    Dunkan 4 weeks ago

    In a case like this, I would first precisely determine the system’s operating pressure range and maximum flow rate. On our test bench, we also needed to change the pressure frequently, so choosing the right valve wasn’t exactly straightforward. To replace a single component, I ordered find Danfoss hydraulic parts after first verifying the specifications of the old valve. It’s also important to check the connection type and dimensions so you don’t have to modify the hydraulic line. If the valve will be used frequently, I would also consider the control method and the allowable load. It’s good to know the pump’s maximum pressure in advance, not just the typical operating pressure. I’d also check how precisely the set pressure needs to be maintained in different operating modes. What pressure range do you use on your test bench?

Please login or register to leave a response.